Hello Guest it is May 04, 2025, 04:13:59 PM
Profile Guest
« previous next »
Pages: 1   Go Down

Author Topic: MACRO- LATHE DRILLING MACRO - G83  (Read 18660 times)

0 Members and 1 Guest are viewing this topic.

Offline RICH

*
  • *
  • 7,427 7,427
MACRO- LATHE DRILLING MACRO - G83
« on: November 27, 2013, 05:07:33 PM »
M1083 was replaced in some later Mach versions with one that did not work completely.
There were issues with the macro where Z will feed back in after the retract rather than rapid back in.

Replace your existing one with the attached one.

REFERENCE POST:
http://www.machsupport.com/forum/index.php/topic,25964.msg183017.html#msg183017
« Last Edit: November 27, 2013, 05:20:57 PM by RICH »
Logged
Pages: 1   Go Up
« previous next »