Upgraded to new hardware, Turn won,t run

[milehigh51]

Hi All
I upgraded to new hardware MB AMD 145 Single core processor.
When I load Mach3 Turn it locks up the CPU. Mach3 mill loads fine.
I have tried several versions of mach with the same results
Thank You

Roy

[Hood]

Do you have any brains or a macropump or any plugins in Turn that you dont in mill? Do you have a high kernel chosen in Turn?
If you attach your xml I will have a look and see if I can spot any issues.
Hood

[milehigh51]

Hi Hood

Thanks for the reply.  I did find the problem.  In the bios disabled the following
secure virtual machine
power now
acpi srat table
C1E

This mother board is a Biostar  AMD 3 chip set.
I hope this may help someone else.

Roy