after the crash - episode 2

Welcome, Guest. Please login or register.
Did you miss your activation email?
May 28, 2012, 09:36:52 AM

Machsupport Forum

Mach Discussion

General Mach Discussion

after the crash - episode 2

Pages: 1 Go Down

« previous next »

	Author	Topic: after the crash - episode 2 (Read 169 times)
0 Members and 2 Guests are viewing this topic.

Fred_evans

Active Member

Offline

Offline

Posts: 126

after the crash - episode 2

« on: December 22, 2011, 03:45:34 AM »

I am not going to reinstall because I am scared of loosing the calibrations

Can I re install and not have to recalibrate everythinh again

regards fred evans


	Logged

think of the trees-- use both sides of the computer paper

Tweakie.CNC

Active Member

Offline

Offline

Posts: 3,263

Super Kitty.

Re: after the crash - episode 2

« Reply #1 on: December 22, 2011, 08:28:16 AM »

Hi Fred,

All of your previous set-up will be stored in the .xml file (named as the profile you are using .xml) and located in you Mach3 folder. Copy this file, save it somewhere safe (memory stick is good), then use it to over - right the new .xml file after the re-install. It is also wise to keep a copy of your license file and screen set, just in case everything gets deleted.

Tweakie.


	Logged

Success consists of going from failure to failure without loss of enthusiasm. Winston Churchill.

Pages: 1 Go Up

« previous next »

Jump to: