Welcome, Guest. Please login or register.
Did you miss your activation email?
May 28, 2012, 10:30:19 AM

Login with username, password and session length
Search:     Advanced search
* Home Help Search Calendar Links Login Register
+  Machsupport Forum
|-+  Mach Discussion
| |-+  General Mach Discussion
| | |-+  problem with a post processor
Pages: 1   Go Down
« previous next »
Print
Author Topic: problem with a post processor  (Read 138 times)
0 Members and 1 Guest are viewing this topic.
jonny quest
Active Member

Offline Offline

Posts: 101


View Profile
« on: December 10, 2011, 07:10:08 PM »
my Z is moving up so it will just cut air... attached is post processor file and I'm just pasting first lines of code

G00 G49 G40.1 G17 G80 G50 G90 G64
G20
(.25 Flat faced Center cutting 4 flute HSS)
M6 T1
M03 S2000
G01Z0.000
G01X-0.229Y0.541Z1.017 F60
X-0.185Y0.525Z1.010 F60
Y0.568Z1.003
X-0.449Z0.961
X-0.625
Y0.525
X-0.581Y0.541
X-0.537Y0.553
X-0.518Y0.558
X-0.493Y0.562
X-0.449Y0.567
X-0.361Y0.567
X-0.317Y0.562
X-0.293Y0.558
X-0.273Y0.553
* Mach_3_Inch.txt (0.79 KB - downloaded 13 times.)
Logged
jonny quest
Active Member

Offline Offline

Posts: 101


View Profile
« Reply #1 on: December 10, 2011, 10:38:34 PM »
i think i have it figured out. post seems fine... drawing wasn't in a correct position... gave funny gcode results
Logged
Pages: 1   Go Up
Print
« previous next »
Jump to:  

Powered by MySQL Powered by PHP Powered by SMF 1.1.16 | SMF © 2011, Simple Machines Valid XHTML 1.0! Valid CSS!