Call plasma mode with gcode?

[MKroe]

Hi all,
Have been a lurker here for a long time. I have been using M3 for awhile now and have been using plasma mode for over 6 months when doing 2.5d, as well as arcs and such. This tends to eliminate the jerky point to point cutting when milling at high feedrates.

Now My question, Is there a way to call plasma mode with Gcode, Using say an M or G call? I have a need to change from CV or exact stop to Plasma and back during some milling. I can use  G61/G64 call from Exact stop to CV but that does not accomplish what I need

thanks

MK

[BR549]

I don't know of any way to turn on the CV plasma mode OTHER than the Genconfig window.

(;-) TP

[MKroe]

That's what I'm think as well BR549. It would sure make things easier though for me if I can.