Black Friday in my CNC world

[ger21]

In General Config, check "Persistent DRO's" in the lower right corner

[Jim1245]

I have done that but it still doesn't retain the setting.

[Chaoticone]

Do you have optional offset save checked in general config as well? If so you should get a popup when closeing Mach asking if you want to save current offset.

Brett

[Jim1245]

Optional offset save is checked. However, when exiting program values default to X +1.0904, Y-.3159, Z-2666.
It doesn't matter if I say Yes to Fixture Save or No.
Then I have to Reset X,Y,Z back to 0 every time.

[ger21]

If it's not at 0,0,0 when you exit Mach3, it won't be at 0,0,0 when you restart it. If you're zeroing X and Y any time while using MAch3, you're setting a G54 offset, which will be in effect when you restart Mach3.

Sounds like you may want to uncheck all those boxes in the lower right corner?

[Jim1245]

It was at 0,0,0 when I exited but when I returned it was always different.

Unchecking those boxes retains 0,0,0.

You are correct, thank you.