Wacky axis movement

Welcome, Guest. Please login or register.
Did you miss your activation email?
May 28, 2012, 10:04:25 AM

Machsupport Forum

Mach Discussion

General Mach Discussion

Wacky axis movement

Pages: « 1 2 Go Down

« previous next »

	Author	Topic: Wacky axis movement (Read 392 times)
0 Members and 2 Guests are viewing this topic.

Tweakie.CNC

Active Member

Offline

Offline

Posts: 3,263

Super Kitty.

Re: Wacky axis movement

« Reply #10 on: November 06, 2011, 02:54:51 AM »

Don,

If your motor tuning is in mm (and it is correct) then just convert the metric entries to inch units (eg. 320 steps / 25.4 = 12.5984 steps) and so on for Vel. and Acc. - remember to save each axis settings before proceeding to next axis. Also make sure Config. / Select Native Units is set to inches. Then test it thoroughly and if necessary make any small adjustments to Vel. and Acc. to obtain the best, 100% reliable, performance.

Tweakie.


	Logged

Success consists of going from failure to failure without loss of enthusiasm. Winston Churchill.

dwilliams56

Active Member

Offline

Offline

Posts: 11

Re: Wacky axis movement

« Reply #11 on: November 06, 2011, 09:04:08 AM »

Thanks Tweakie


	Logged

Tweakie.CNC

Active Member

Offline

Offline

Posts: 3,263

Super Kitty.

Re: Wacky axis movement

« Reply #12 on: November 06, 2011, 12:14:54 PM »

My pleasure sir Wink

Tweakie.


	Logged

Success consists of going from failure to failure without loss of enthusiasm. Winston Churchill.

Pages: « 1 2 Go Up

« previous next »

Jump to: