Welcome, Guest. Please login or register.
Did you miss your activation email?
May 28, 2012, 08:36:01 AM

Login with username, password and session length
Search:     Advanced search
* Home Help Search Calendar Links Login Register
+  Machsupport Forum
|-+  Mach Discussion
| |-+  General Mach Discussion
| | |-+  Using rg-59 TV cable for home and limit switch(s)
Pages: 1   Go Down
« previous next »
Print
Author Topic: Using rg-59 TV cable for home and limit switch(s)  (Read 235 times)
0 Members and 2 Guests are viewing this topic.
geone
Active Member

Offline Offline

Posts: 23


View Profile
« on: October 11, 2011, 02:32:21 PM »
Has anyone used TV cable for limit and home switch wiring.  It is totally shielded and a single conductor for series switch setup...the downside?
Logged
BR549
Active Member

Offline Offline

Posts: 2,557


View Profile
« Reply #1 on: October 11, 2011, 02:47:33 PM »
YOU end up with a LOT of rigid cable hanging around your machine. For each switch you still have to have wires going to the switch and away from switch. IF you daisey chain them it makes it worse sometimes. AND the wire is normally rigid core easier to have break due to vibration and flexing.

BUT if that is all you have access to better than nothing(;-)

(;-) TP
Logged
Tweakie.CNC
Active Member

Offline Offline

Posts: 3,263


Super Kitty.


View Profile WWW
« Reply #2 on: October 12, 2011, 01:41:54 AM »
My view is that it will just lead to problems at a later date.
It is not expensive to buy and two core shielded cable will make a much better job.

Tweakie.
Logged
Success consists of going from failure to failure without loss of enthusiasm.  Winston Churchill.
geone
Active Member

Offline Offline

Posts: 23


View Profile
« Reply #3 on: October 14, 2011, 12:04:54 PM »
thanks for the info
geo
Logged
Pages: 1   Go Up
Print
« previous next »
Jump to:  

Powered by MySQL Powered by PHP Powered by SMF 1.1.16 | SMF © 2011, Simple Machines Valid XHTML 1.0! Valid CSS!