Save fixture

[fragger6662000]

Gent's and ladies

I have been using mach for many years but just using the base co-ordinantes without using G54 or G28 commands, I don't see the need to run them on this machine as i don't have multiple setup on the machine and no repeatable tooling for length.

anyway i have switch to a different cam which uses g28 and g54 and i have a lathe setup and mill setup on the same machine.

When i exit and save fixture and reload it now does not remember the position.

Or is it just showing the g53 and not the g54 wcs?

thanks matt

[Hood]

The DROs show G54 by default, G53 is only seen when you have MachineCoOrds button active.
Have a look at General Config page and see if you have persistent offsets and DROs chosen.
Hood

[fragger6662000]

i will hava a look.

thanks

[fragger6662000]

seam tohave had that selected. another hood rescue!