Mach3 Mill

[InoMachMill]

i facing a problem during homing process :-
current setting is :
a. Auto Zero disable
b. with Galil PCI motion card , all axis homing is OK - turn to yellow when active (M1 Home, M2 Home and M3 Home)

during homing ,Z Axis will doing homing first , the Z Axis will move up untill Home Sensor Triggered and it move down , it continuously mov down
although Home sesnor already OFF untill hit the limit , Why ? any setting wrong ?

[Hood]

This will likely be a question you should ask in the Galil section as it would seem to be specific to it.
Hood