CNC screw

Welcome, Guest. Please login or register.
Did you miss your activation email?
May 28, 2012, 01:44:08 AM

Machsupport Forum

Mach Discussion

General Mach Discussion

CNC screw

Pages: 1 Go Down

« previous next »

	Author	Topic: CNC screw (Read 287 times)
0 Members and 2 Guests are viewing this topic.

Gabe

Holding

Offline

Posts: 1

CNC screw

« on: July 12, 2011, 04:30:13 PM »

Good Morning to everybody

I'm novice in cnc machine, I've bought a 3 axis but I've seen that one of the screww has an eccessive game so I want to substitute with ballscrew one.This last has different step.

My question is the following

Can Mach3 software be programme to accept a different step of a different screw? if yes, how is possible that?

Best Regards


	Logged

Tweakie.CNC

Active Member

Offline

Offline

Posts: 3,263

Super Kitty.

Re: CNC screw

« Reply #1 on: July 13, 2011, 01:15:16 AM »

Hi Gabe,

Mach3 has no problem with this.

If you click "Config" then "Motor Tuning" you will see where steps per unit are entered. Select the Axis concerned, enter the new steps then click Save Axis Settings.

Tweakie.


	Logged

Success consists of going from failure to failure without loss of enthusiasm. Winston Churchill.

RICH

Global Moderator

Offline

Posts: 4,709

Re: CNC screw

« Reply #2 on: July 13, 2011, 09:01:52 PM »

It's not restictive like some other controller programs out there.
RICH


	Logged

Pages: 1 Go Up

« previous next »

Jump to: