well after wanting to push my cnc wood router out the door pour gas on it burn it to the ground.
dance and chant at it destruction .
i feel better now
i have all of my limit sw in and working .
table is 24x 74.5 in as of now if redo my limit sw can get another 3in anyway
200 stepper mtr
# 25 chain and 9 tooth 1/4 pitch sprockets 2.250 per rev
drivers set 1/16 x y and
z axis 10 tpi with 5 starts points
1435.11per step per unit i was 0.012 over 74.5 in of travel i have had a tuff time figuring this out
set gantry router bit at 37.250 zero x axis middle of x axis
i go to setting to step per unit x axis pick a axis to calibrate 2 in check with dro caliper I'm at 2 in
i jog back to zero middle of table i us the pick a axis to calibrate x azis this time
step per unit X axis 20.0in it gose 20.0 in im right on 20.0
again i go steps per unit -20.0 to go back to zero middle of table X axis moves 19.5 in i m not doing math right
dont understand
mikee
not much land dam few cattle and if the river keep going up i wont have any land
