Welcome, Guest. Please login or register.
Did you miss your activation email?
May 27, 2012, 11:50:12 PM

Login with username, password and session length
Search:     Advanced search
* Home Help Search Calendar Links Login Register
+  Machsupport Forum
|-+  Mach Discussion
| |-+  General Mach Discussion
| | |-+  Mach3 cannot send out signal
Pages: 1   Go Down
« previous next »
Print
Author Topic: Mach3 cannot send out signal  (Read 203 times)
0 Members and 2 Guests are viewing this topic.
renxiang
Active Member

Offline Offline

Posts: 4


View Profile
« on: June 27, 2011, 06:13:19 PM »
Hello,
I have a problem, I connected the serial port to breakout board, but when I run Mach3, there's no signal sending out through the breakout board, nor the serial port. Any one knows the reason?
Xiang
Logged
Hood
Active Member

Offline Offline

Posts: 17,366


Carnoustie, Scotland


View Profile
« Reply #1 on: June 28, 2011, 01:56:00 AM »
You need to use the parallel port rather than the serial port.
If you are using the parallel port then check you have the correct address set in Mach for it.
Hood
Logged
Tweakie.CNC
Active Member

Offline Offline

Posts: 3,263


Super Kitty.


View Profile WWW
« Reply #2 on: June 28, 2011, 01:57:27 AM »
Post deleted - I totally misunderstood the question.

Tweakie.
« Last Edit: June 28, 2011, 02:02:17 AM by Tweakie.CNC » Logged
Success consists of going from failure to failure without loss of enthusiasm.  Winston Churchill.
Pages: 1   Go Up
Print
« previous next »
Jump to:  

Powered by MySQL Powered by PHP Powered by SMF 1.1.16 | SMF © 2011, Simple Machines Valid XHTML 1.0! Valid CSS!