Welcome, Guest. Please login or register.
Did you miss your activation email?
May 27, 2012, 08:44:02 PM

Login with username, password and session length
Search:     Advanced search
* Home Help Search Calendar Links Login Register
+  Machsupport Forum
|-+  Mach Discussion
| |-+  General Mach Discussion
| | |-+  halfmoon instead of circle
Pages: « 1 2 3 4 5 6 7   Go Down
« previous next »
Print
Author Topic: halfmoon instead of circle  (Read 2226 times)
0 Members and 2 Guests are viewing this topic.
cheech669
Active Member

Offline Offline

Posts: 34



View Profile
« Reply #60 on: May 17, 2011, 08:16:55 AM »
Turns out the tip voltage was wired - to + even though the install said the only thing polarity sensative wasn't the raw tip voltage I did need to flip them.  Now an other problem and I rreally hope the last one is that on larger parts the torch shuts off during the cut.  The torch is off, the thc says there is no arc, yet mach3 shows the torch still on.  The movement does stop about 2 inches after the torch has shut off.  Anything larger then 11 inches does not get to be cut all the way.
Logged
cheech669
Active Member

Offline Offline

Posts: 34



View Profile
« Reply #61 on: May 17, 2011, 12:52:42 PM »
ok Finaly got a hold of someone who knows the thc.  Torch rate was set too high.  Now it seems to be doing fine.
Logged
Pages: « 1 2 3 4 5 6 7   Go Up
Print
« previous next »
Jump to:  

Powered by MySQL Powered by PHP Powered by SMF 1.1.16 | SMF © 2011, Simple Machines Valid XHTML 1.0! Valid CSS!