Welcome, Guest. Please login or register.
Did you miss your activation email?
May 27, 2012, 08:04:06 PM

Login with username, password and session length
Search:     Advanced search
* Home Help Search Calendar Links Login Register
+  Machsupport Forum
|-+  Mach Discussion
| |-+  General Mach Discussion
| | |-+  motors not turning
Pages: 1   Go Down
« previous next »
Print
Author Topic: motors not turning  (Read 239 times)
0 Members and 1 Guest are viewing this topic.
RAUL
Active Member

Offline Offline

Posts: 2


View Profile
« on: April 14, 2011, 03:10:08 PM »
NEW ON CNC - can  the stepper motors move when you install MACH3 DEMO?
I'm using C35 breakout board,a digital stepping driver and motors KL23H286-20-8b from KELINGINC ELECTRONIC  and I can't make the motor to turn,Help!!
Logged
Mishawaka
Active Member

Offline Offline

Posts: 25


View Profile
« Reply #1 on: April 14, 2011, 03:38:37 PM »
Does your controller need a specific XML file? My Gecko requires one for it to work.
Logged
RAUL
Active Member

Offline Offline

Posts: 2


View Profile
« Reply #2 on: April 14, 2011, 03:48:37 PM »
Thanks,let me look into?
Logged
Tweakie.CNC
Active Member

Offline Offline

Posts: 3,263


Super Kitty.


View Profile WWW
« Reply #3 on: April 15, 2011, 01:28:52 AM »
Hi Raul,

Welcome to the forum.

The Mach3 demo version will work just fine.

Your C35 requires an enable signal to get any output - check that the EN terminal is connected to +5Volts.

Hope this helps.

Tweakie.
Logged
Success consists of going from failure to failure without loss of enthusiasm.  Winston Churchill.
Pages: 1   Go Up
Print
« previous next »
Jump to:  

Powered by MySQL Powered by PHP Powered by SMF 1.1.16 | SMF © 2011, Simple Machines Valid XHTML 1.0! Valid CSS!