Welcome, Guest. Please login or register.
Did you miss your activation email?
May 27, 2012, 06:52:26 PM

Login with username, password and session length
Search:     Advanced search
* Home Help Search Calendar Links Login Register
+  Machsupport Forum
|-+  Mach Discussion
| |-+  General Mach Discussion
| | |-+  help please
Pages: « 1 2   Go Down
« previous next »
Print
Author Topic: help please  (Read 653 times)
0 Members and 2 Guests are viewing this topic.
Tweakie.CNC
Active Member

Offline Offline

Posts: 3,263


Super Kitty.


View Profile WWW
« Reply #10 on: March 29, 2011, 02:50:09 AM »
Could be.
Look to see if 'Safe Z' under the config tab is enabled.

Tweakie.
Logged
Success consists of going from failure to failure without loss of enthusiasm.  Winston Churchill.
agguilar
Active Member

Offline Offline

Posts: 42


View Profile
« Reply #11 on: March 29, 2011, 11:05:06 PM »
sorry is not z axis Embarrassed is Y axis 
Logged
Tweakie.CNC
Active Member

Offline Offline

Posts: 3,263


Super Kitty.


View Profile WWW
« Reply #12 on: March 30, 2011, 01:25:01 AM »
OK, assuming you are getting to the last line of your GCode (M30) when it is run then my opinion is that the problem is within your controller rather than Mach or your setup. The M30 should terminate any pulses from Mach so what could be driving your Y axis ?

Tweakie.
Logged
Success consists of going from failure to failure without loss of enthusiasm.  Winston Churchill.
Pages: « 1 2   Go Up
Print
« previous next »
Jump to:  

Powered by MySQL Powered by PHP Powered by SMF 1.1.16 | SMF © 2011, Simple Machines Valid XHTML 1.0! Valid CSS!