How to make Mach 3 to stop after every G-code line?

[flyingpickles]

Hello I shall do a stop motion animation and I will use Mach 3 to move the camera to the right position for every single shot with the camera. Therefore I will do a G-code with the correct cordinates for the camera for every shot and the question is can I make mach 3 to stop after every G-code line so it just move the camera a tiny bit and continue to the next position when I press a button on the keyboard or so?

Thanks for helping me! 

[Overloaded]

Sure.
Turn on Single Block and the code will run one line for each Cycle Start button press.
Russ

[Hood]

Use Single Block button and it will do one line and wait for you to press start. If thats noot what you want can you explain more?
Hood

[flyingpickles]

Ok, yes that was what I searched for, thx