Hesitation between Lines of G-code

[Hood]

Ok tried the code with your xml and I dont see any hesitation in the toolpath view or by watching the units per min DRO. Can you run the driver test and see what that is like.
The IJ mode is set with G90.1 or G91.1, the code you posted is Inc IJ mode so G91.1 would be inthe header.
Hood

[Dan Sjo]

Hi Hood,

Thanks for checking that out. What's the driver test? Seems like I'm discovering new Mach features all the time...

Thanks for the G Code tip too. I'll change my header in my post and config.

Dan