Welcome, Guest. Please login or register.
Did you miss your activation email?
May 27, 2012, 11:52:16 AM

Login with username, password and session length
Search:     Advanced search
* Home Help Search Calendar Links Login Register
+  Machsupport Forum
|-+  Mach Discussion
| |-+  General Mach Discussion
| | |-+  E-Stop stuck on
Pages: 1   Go Down
« previous next »
Print
Author Topic: E-Stop stuck on  (Read 398 times)
0 Members and 1 Guest are viewing this topic.
cncdaddy
Active Member

Offline Offline

Posts: 13


View Profile
« on: February 03, 2011, 10:11:40 PM »
HI, I'm having an issue with my E-stop. I can reset it (in the software) but it immediately comes back on. I have restarted my CPU, tried messing with the physical E-stop but to no avail. I'm new at this CNC thing so this is really slowing down my learning process since I cannot even get my machine to jog etc. while it is in the E-stop mode.
Any advice would be greatly appreciated.
Logged
Hood
Active Member

Offline Offline

Posts: 17,362


Carnoustie, Scotland


View Profile
« Reply #1 on: February 04, 2011, 01:59:44 AM »
Sounds like you are getting electrical noise on the E-Stop signal, best to shield the wires properly if that is the problem but setting a debouce interval of 2000 might mask the issue until you can do that. You will find it from Config menu then General Config.
Hood
Logged
Pages: 1   Go Up
Print
« previous next »
Jump to:  

Powered by MySQL Powered by PHP Powered by SMF 1.1.16 | SMF © 2011, Simple Machines Valid XHTML 1.0! Valid CSS!