Newbie Problem

[ronald4418]

Whenever I open Mach3, I end up with an error message that states " Initialization Macro called upon reset". What is it and how do I rectify the problem?

[Jeff_Birt]

That is not an 'error', it is just informational. If you look in the general configuration window, you will see a section that controls what happens on initialization/start up (called Startup Modals). Generally it is a very good idea to have your control start up in a known state so if you try and jog you know what will happen (for example). The message is just letting you know that the initialization has been done.

[ronald4418]

Thank you very much for your quick response.