Mix and match motors

Welcome, Guest. Please login or register.
Did you miss your activation email?
May 27, 2012, 11:45:41 AM

Machsupport Forum

Mach Discussion

General Mach Discussion

Mix and match motors

Pages: 1 Go Down

« previous next »

	Author	Topic: Mix and match motors (Read 288 times)
0 Members and 1 Guest are viewing this topic.

dresda

Active Member

Offline

Offline

Posts: 150

Mix and match motors

« on: February 02, 2011, 12:29:56 AM »

Is it possible to use my 3 Dc servo motors with 10 v analogue and DSPMC unit and a stepper motor with it's own drive for the rotary table.
Ray.


	Logged

Tweakie.CNC

Active Member

Offline

Offline

Posts: 3,263

Super Kitty.

Re: Mix and match motors

« Reply #1 on: February 02, 2011, 02:24:40 AM »

Hi Ray,

In short yes.
Mach outputs step and direction signals (in an open ended manner) and it really does not care what type of drives/motors you are using.

Tweakie.


	Logged

Success consists of going from failure to failure without loss of enthusiasm. Winston Churchill.

Hood

Active Member

Offline

Offline

Posts: 17,362

Carnoustie, Scotland

Re: Mix and match motors

« Reply #2 on: February 02, 2011, 03:03:22 AM »

I dont think the DSPMC can use Step/Dir drives so I would say no. Rufi will be able to give you a definitive answer though.
Hood


	Logged

Tweakie.CNC

Active Member

Offline

Offline

Posts: 3,263

Super Kitty.

Re: Mix and match motors

« Reply #3 on: February 02, 2011, 05:05:16 AM »

Ooops,
Hood is quite right, I was only considering mixing servo drivers and stepper drivers and not operation of Mach under the DSPMC plugin. Embarrassed

Tweakie.


	Logged

Success consists of going from failure to failure without loss of enthusiasm. Winston Churchill.

Pages: 1 Go Up

« previous next »

Jump to: