Step Morphing Question

[michaelthomas]

I just bought some 203V drives fro my new router.  After reading about it's micro to full step morphing, I wondered if a higher top speed could be achieved without the need to raise the kernel speed. 

I will be using 4032 steps per inch, and at a kernel speed of 45000.....I would top out at 669 IPM.  Would that increase using the 203v's ?

[HimyKabibble]

No, the step morphing is completely transparent to the CNC controller.

Regards,
Ray L.

[michaelthomas]

Thank you!