Jogging off the stops

[jimthefish]

Hi, my Mach3 crashed last week, I reprogrammed in all the config and got it all back to normal. However when I hit the stops I can't get the axis to jog off the stop. I'm sure there was a tick box to allow you to jog off the stop but cant remember how I did it. Can anyone JOG my memory

[Hood]

Auto Limit Override on I think the settings page.
Hood

[jimthefish]

Hi Hood, I knew you would know mate. Thanks, How are you, Jim

[Hood]

Fine Jim
BTW you may want to look at setting soft limits also as it will prevent you from hitting the limits in the majority of cases.
Hood

[jimthefish]

OK will do. Just for reference the machine has run perfect since you helped out. I make Model Steam trains down in a small workshop down the garden. It got so cold over the past couple of weeks I think it froze the machine, had to put some heat into the machine castings via a blow heater. When I came to switching on the computer the Mach3 setting had dissapeared, frozen out?. Still all OK now, back to my chu chues. Jim