Welcome, Guest. Please login or register.
Did you miss your activation email?
May 27, 2012, 12:48:55 PM

Login with username, password and session length
Search:     Advanced search
* Home Help Search Calendar Links Login Register
+  Machsupport Forum
|-+  Third party software and hardware support forums.
| |-+  Galil (Moderators: smurph, kcrouch)
| | |-+  Problem in Motor Tuning
Pages: 1   Go Down
« previous next »
Print
Author Topic: Problem in Motor Tuning  (Read 440 times)
0 Members and 2 Guests are viewing this topic.
Shivu
Active Member

Offline Offline

Posts: 18


View Profile
« on: December 29, 2010, 02:09:19 AM »
Hi all,

I am trying to change the value of step per in the motor tuning, when i changed the value of step per to any value the Graph disappears and the velocity will become ZERO. and i am not able to enter the velocity the velocity will become ZERO even if  enter the new velocity value.

Any solutions?

Shivu.
Logged
smurph
Active Member

Offline Offline

Posts: 244


View Profile
« Reply #1 on: December 29, 2010, 08:25:10 PM »
I'm not sure on this one.  Some parameter is not right.  You might post this question to the General section and get more responses.

Steve
Logged
HighOctane
Active Member

Offline Offline

Posts: 16


View Profile
« Reply #2 on: December 29, 2010, 10:13:54 PM »
Just in case you ran into the same problem as I did... Go to Config > Ports & Pins > Motor Outputs. Make sure the axes you want to run are enabled with the check mark. Last week I was unable to use the Motor Tuning menu in mach and the graph was not working right either... It was because I had not enabled the axes in the Motor Outputs tab.

Josh G.
Logged
Pages: 1   Go Up
Print
« previous next »
Jump to:  

Powered by MySQL Powered by PHP Powered by SMF 1.1.16 | SMF © 2011, Simple Machines Valid XHTML 1.0! Valid CSS!