Welcome, Guest. Please login or register.
Did you miss your activation email?
May 27, 2012, 12:47:44 PM

Login with username, password and session length
Search:     Advanced search
* Home Help Search Calendar Links Login Register
+  Machsupport Forum
|-+  Third party software and hardware support forums.
| |-+  PoKeys (Moderator: NeoTO)
| | |-+  PoPendant pdf help
Pages: 1   Go Down
« previous next »
Print
Author Topic: PoPendant pdf help  (Read 421 times)
0 Members and 1 Guest are viewing this topic.
M250cnc
Active Member

Offline Offline

Posts: 591




View Profile
« on: December 28, 2010, 01:44:49 PM »
In the popendant pdf pin 5 says connect to N.C.

What pin is that please.

Phil

Sent from my HTC Desire using Tapatalk
Logged
The Good Thing About Mach3, Is It's very Configurable

The Bad Thing About Mach3, Is It's Too Configurable
borisz
Active Member

Offline Offline

Posts: 209



View Profile WWW
« Reply #1 on: December 28, 2010, 03:14:59 PM »
Hi!

Writing user manuals is very time consumpting work. To be honest nobody like these work, but we are writing them to help customers.
So, please READ USER MANUAL. It is not very hard and we put a lot of efforts in them.
In the same table at the bottom line, you have explanation for these: "NC.= not connected"
Simple?

regards

Boris
Logged
www.poscope.com home of PoKeys USB HID, IO, USB, Ethernet controler and PoScope USB PC oscilloscope
M250cnc
Active Member

Offline Offline

Posts: 591




View Profile
« Reply #2 on: December 28, 2010, 04:33:10 PM »
Boris thanks for your answer.

Lamps normally have two wires connected, hence my question.

Better be safe than sorry.

Phil

Sent from my HTC Desire using Tapatalk
Logged
The Good Thing About Mach3, Is It's very Configurable

The Bad Thing About Mach3, Is It's Too Configurable
Pages: 1   Go Up
Print
« previous next »
Jump to:  

Powered by MySQL Powered by PHP Powered by SMF 1.1.16 | SMF © 2011, Simple Machines Valid XHTML 1.0! Valid CSS!