Remot Pendent for Galil

[Shivu]

I need to use remote push buttons for galil for the operators convenience like start, stop, spindle on, can any one guide me how to do this with Mach3 and Galil. 

[smurph]

In general, you would wire these buttons to an input.  And then you would use a Brain to take the appropriate action.  Have a look at the tutorials here: http://www.machsupport.com/videos/

Steve

[Shivu]

Hi Steve,

Thank you very much for your information, i am able to set up the remote pendent after checking up the videos.

Shivu