Having an issue with arcs O ring pocket code.

[fixittt]

We are having an issue with this g code.  It works on a HAAS machine fine.
Problem is, its suppost to cut an o ring grove .5 inchs in diameter.  But its giving us a 1 inch or better pocket.

Any ideas? Problems that you may see?

[Hood]

Works fine here, think you may have the IJ mode set wrong, change it from General Config page from Abs to Inc.
Hood

[fixittt]

That did it!  Thanks!  I dont deal much with arc fitted toolpath with what I do........  THANKS BUNCHES!

[Hood]

Really your code should define the mode, if you had a G91.1 at the beginning of the code it would have run fine even though Mach was set to Abs (G90.1) the code would have overridden Machs default.
Hood

[fixittt]

I will pass that info along to the end user,  Thank you!  I dont know enough about arc toolpath yet. 

[Hood]

You probably know more than me

Hood