Tribal Router II Ports and Pins Help!

[NolanDubyu]

So had some computer issues last week, long story short I have a new computer. Talked with Keith at Vortech and he told me all I needed was the Ports and Pins configuration and I would be good to go again. Received the email this morning, it's an XML file and I believe I am supposed to copy-paste it to a Tribal Router II file, the only thing is, I have no clue how to get there and they're not very big on answering the phone at Vortech, so now I'm here. Any help would be greatly appreciated.

Thanks,
Nolan

[budman68]

Nolan,

Keep in mind, I know nothing about Vortech, but an XML file "should" go into the Mach 3 folder if that's what you are using?

Dave

[NolanDubyu]

Correct, Mach 3. That's the thing though I'm not sure what file I am supposed to paste it into.

[budman68]

Ok, great, then just drop the xml file into the Mach 3 folder and you should be able to find that profile when you click on the Mach 3 "loader" icon on your desktop. That will start up your Mach s software with the correct XML configuration that you received from Vortech.

Hope that helps-
Dave

[NolanDubyu]

Where do I find this Mach 3 folder? All I have is: Mach 3 Loader, Mach 3 Plasma, Mach 3 Mill, Mach 3 Mill and Mill on my desktop.

Nolan

[budman68]

This Mach 3 folder is in the directory on the hard drive on your computer, wherever you (or Vortech) installed Mach 3. The default place is the C: Hard drive.

Dave

[NolanDubyu]

Ok, so just place the XML file in there and that'll work?

Thanks,
Nolan

[budman68]

Again, I know nothing about Vortech but the XML should have all the info that is required to run your machine.

Test at YOUR own risk or contact Vortech for confirmation!!

Dave

[NolanDubyu]

Alright, I finally got it! Thanks for all of your help.

Nolan

[budman68]

Excellent, thanks for letting us know.

Dave