NEWBEE problem with tb6560 and mach3

[gurasha]

hello to everybody

just instaled mach3 and board tb6560. motors have no reaction on software. motors don't move. I allready  have run drivertest. can u give me any suggestions?

[Hood]

First thing is look and see if DROs move in Mach when you jog, if they do then check you have the correct port address set. Next would be to put a volt meter between the Dir pin and 0V of each axis in turn and jog the axis back and forward and see if the voltage changes between 0v and 5v.

Hood

[leaveme]

hello to everybody

just instaled mach3 and board tb6560. motors have no reaction on software. motors don't move. I allready  have run drivertest. can u give me any suggestions?

I'm pretty sure that your port config is not correct. I have had the same problem for one of my eBay TB6560 boards. Their port config (provided in CD) was completely wrong. I then manually traced the board to identify the pin config. Finally it worked.