Possible problem with Surfacing wizard

[titchener]

Brian-

I has posted this a while back in the Yahoo mach forum, but the forum was really busy then and it might have slipped by you, I didn't see a response.

(originally posted on Yahoo mach forum)
Brian-

When using the Surfacing Material Wizard, the starting point for me is
always the upper left hand corner of the defined material, independent
of the selection I make for Start Position.

By the way, thanks for upgrade that automatically calculates chip load
based on the tool properties.

Paul T.

[Brian Barker]

Yea it is going to start in the same place every time:( The points are to change where the X0 Y0 is not the start point.

Hope that helps, and I am sorry I didn't see the message

[titchener]

> The points are to change where the X0 Y0 is not the start point.

Whoops, a senior moment on my part, that makes more sense.

Paul T.