ref all home setup

[gjmoule]

Thanks all. Have got it working On with the next callenge.....will no doubt be back to pick your brains

[bill-the-cat]

For the benefit of others, what was the problem?

[jfca440]

I need some help on getting a dxf file to load into lazycam.  I make my dwgs in autocad, save as dxf and try to open in lazycam, but the dxf file does not show up....Can anyone help?

[budman68]

I need some help on getting a dxf file to load into lazycam.  I make my dwgs in autocad, save as dxf and try to open in lazycam, but the dxf file does not show up....Can anyone help?

Just for the future, you should try to post LazyCam questions in the LazyCam area of the forum and start a new thread.

As for the DXF issue, try saving it as an 11/12 vesrion of a DXF. Also, I personally used to use AutoCad, but had similar problems exporting. Then I switched to ProgreCad (free autoCAD clone) and I haven't had issues after that.

Dave

[angel tech]

For the benefit of others, what was the problem?

yes, what cured the problem, and what was it eventually.