help me plz

Welcome, Guest. Please login or register.
Did you miss your activation email?
February 12, 2012, 01:43:59 AM

Machsupport Forum

Mach Discussion

FAQs

help me plz

Pages: 1 Go Down

« previous next »

	Author	Topic: help me plz (Read 450 times)
0 Members and 1 Guest are viewing this topic.

whitebear

Active Member

Offline

Offline

Posts: 3

help me plz

« on: September 02, 2010, 08:05:28 PM »

ok at are school we have a new cnc mill and program we got it to run last year but it isn't working now the program runs but i think it doesn't send the data to the cnc mill we use the maxpath 42 and im the person that is basically my job to get it running since im independent study we have everything plugged in correctly we believe the mill does work we just can't movie it and no errors pop up when we start the program if you could help me plz and thank you


	Logged

Tweakie.CNC

Active Member

Offline

Offline

Posts: 3,110

Super Kitty.

Re: help me plz

« Reply #1 on: September 03, 2010, 01:14:27 AM »

Have you selected the MaxNC Mode in the Mach Config / Port setup ?

Tweakie.


	Logged

Success consists of going from failure to failure without loss of enthusiasm. Winston Churchill.

whitebear

Active Member

Offline

Offline

Posts: 3

Re: help me plz

« Reply #2 on: September 07, 2010, 12:13:09 PM »

ok i did that and it still din't work and i notice near the reset clear and history buttons on the bottom of the program there is text saying tool 0 = none and i tried to look it up in the manul and found nothing on it if you knew what it meant plz tell me thank you


	Logged

Pages: 1 Go Up

« previous next »

Jump to: