Write Wizard

[sandcrab]

I have tried to to get "Write" in the wizards to load a G code for simple engraving, but it will not post. Last week while working with the wizards and Lazy Cam I received a message that an axis was disabled, but that hasn't repeated. The Lazy Cam G code loads, but all fonts cut double line.

[RICH]

Did you fill in all the inputs, select a single line type of font, but........when all done you need to click the "WRITE" key on the wizard keyboard.
Otherwise it's won't post the gcode. 

RICH

[sandcrab]

That did it Rich, Thanks. I'm not sure if I changed any inputs that mattered, but when I touched the write key, it stayed depressed until the G code had loaded and then reverted to the Mach3 screen and cut single line.