problem with " radius to end of arc differs" error

[arclight]

I'm trying to work on a post for nestmaster  And this is the code I'm coming up with.  I get the radius error on the line 16 and I don't understand why.  I have IJ set to incremental and distance set to absolute. Nestmaster is set to output incremental IJ and absolute otherwise.  I attached the g code any help would be really appreciated

[ger21]

I did't get any errors, using 3.42.020

[arclight]

hmmm I'm using 3.42.040

I'll see if I can switch versions

[hayweyer]

Hello I think I might have figured this out. When you posting G-code in Lazycam make sure the Incremental IJ's (is not checked) and the G-code didn't have that problem. Thanks

[RICH]

Each CAM program has it's owne post processor. I didn't have a problem using 3.042.033 with Absolute and INC IJ modes selected  in general config.
RICH