Feed and Speed Missing from Run screen?

[Stuart NC]

great looking screen set - very practical and user friendly but.......

I have just downloaded and setup MachStdMill but can not see the yellow Feed and Speed control bars shown in in the Run screen jpg under the "introductory information" thread in this forum. Is this a bug, or is there now another method to see and adjust these two parameters?  Thanks, Stuart

[DaveCVI]

This is a difference in the run pages between the 10x7 and 12x9 resolutions  - please see user manual section 3.1.6.
For 10x7 the overrides are located on the fly out page.

Dave

[Stuart NC]

Thanks Dave - I can now understand the difference due to screen resolution.

It was not clear to me that the "user manual" button on the reference screen was specifically for MachStdMill (I thought this was just the normal Mach3 manual). The documentation is good - I now have some reading to do.

[DaveCVI]

He He.
Yes, there is a small "Catch-22" situation there... the section of the user manual for the reference page explains what the user manual button does....  

Dave