corners have radius at higher cut speed

[sparkyengle]

I am having trouble cutting sharp corners at speeds over approx. 10 IPM. If I go faster than that, the corners start to round. If I slow down, it returns to proper cutting. I would cut slower, but it is a pain if I have long strait runs in the same program. I hate having to continuously keep changing my cut speeds. Any help would be appreciated. Thank You!

[khalid]

I think you have CV mode on.. Just go to Config and change CV mode to Exact Stop mode..

[sparkyengle]

That was it! So simple yet has been a pain in my butt for the last year. Thanks So MUCH!!!!