dspmc with mach3 - output problem

[AAndreeww]

Hi!

I have problem with otput0(on the board pin0). When starting axisworks i can control 16 outputs without any problem. When I run mach3 with dspmc plugin, push reset button the output0 goes high. It's strange because i dont have any output assigned in "Port and Pins". It looks like mach3 control this output but i cant find how.
Can you help?

[vitalsystem]

hi AAndreeww

this problem was fixed in early June.  have you downloaded the new plugin? http://www.vitalsystem.com/dspmc

thanks
Rufi

[AAndreeww]

It works now.
thanks a lot.
I have another question. I'd like to use m7,m8,m9 function. I wrote some VB-code in files m7.m1s......
Files are in good destination. When i run spript from script editor it works good. But when i write m7,m8 or m9 in mdi input nothing hapens.
How can i use my function or edit actually built in??
 

[vitalsystem]

I am glad you got it working.  I am not vary familiar with macros.  may be the mach experts who reply to questions in this forum can guide you soon.

regards,
Rufi

[AAndreeww]

I only need to know how the built in m7,m8,m9(coolant) macros are work and how i can use it to my machine.

[TOTALLYRC]

They may be hardwired as part of the Mach base code but I am not sure.
None of my profiles have them in it so I would assume they are hardwired.

Mike

[AAndreeww]

Hi!

I solved my problem. In tab "Port and Pins" >> "Spindle Setup" I set the port for my connection to dsp module.
Then I create a brain which contain open contact "Mist On" and other important for my machine.