Analog +-10VDC controller card

[roncooper]

Okay guys please do not flame me I am starting here at ground zero. I have recently purchased a lagun mill with an anilam 1100 controller. I bought the mill with the intention to upgrade the controller. My question is this. Is there a Galil controller card that will work with my servos? I know they are analog -+ 10VDC I have been on their site but I can't seem to find what I'm looking for, simply because I don't know what I'm looking at. I would like a 5 axis card, right now the machine has two servos (XY) I'd like to find a quill servo for the third, an axis for the spindle, and one to control a rotary table. I have just started data digging, there doesn't seem to be a lot of info on what I'm looking for. Thanks in advance.

[TOTALLYRC]

Hi Ron,
All of the Galil cards support both +-10v analog output along with stepper output IIRC.


Mike

[roncooper]

Thanks Mike I was looking at this card http://www.galilmc.com/products/dmc-21x3.php but it really didn't say anything about output only input. So this card should work for me?

RLC

[TOTALLYRC]

Hi again Ron,
Page 53 of the manual says,
"The DMC-21x2/21x3 command voltage ranges between +/-10V.  This signal, along with GND,
provides the input to the motor amplifiers."

So yes it will work for you.

Mike

[battwell]

the 21x3 cards work really well
just remember you need to price in the i/o daughter card etc when you purchase it
you are limited to 56 i/o on the 21x3 series but im sure this will be enough for a mill