Welcome, Guest. Please login or register.
Did you miss your activation email?
May 26, 2012, 11:20:19 AM

Login with username, password and session length
Search:     Advanced search
* Home Help Search Calendar Links Login Register
+  Machsupport Forum
|-+  Third party software and hardware support forums.
| |-+  Galil (Moderators: smurph, kcrouch)
| | |-+  Encoder feedback
Pages: 1   Go Down
« previous next »
Print
Author Topic: Encoder feedback  (Read 548 times)
0 Members and 1 Guest are viewing this topic.
Flipz01
Active Member

Offline Offline

Posts: 108


View Profile
« on: July 08, 2010, 02:16:25 PM »
I've read through most of the posts here and one of them talks about not reading encoders.  I'm not getting feedback, and I'm not sure why.

I have a DMC-2143 card.  I can see the encoders are working with a TPA command in GalilTools, and if I spin the motor, I can see the Units/min register report the speed in Mach.  But, if Mach reads the encoders to report the speed, why doesn't it display position in the position DRO?  Is there a special type of DRO box for this?
Logged
Pages: 1   Go Up
Print
« previous next »
Jump to:  

Powered by MySQL Powered by PHP Powered by SMF 1.1.16 | SMF © 2011, Simple Machines Valid XHTML 1.0! Valid CSS!