Hi/Low Current

[cap232]

Hi
Can someone help me ??
When I run Mach3, direct on the lpt, my motor control goes Hi/Low Current fine.
But when I use Smoothstep v 1.2 Hi/Low Current don’t run ?
I use the same setup in Output Signal (see the attach file)
When I change Active Low Status in the setup I can get the,[img]http://Hi/Low Current to change,
But I cannot get it to change automatically like when I run direct on my LPT port.

[cap232]

Hi

I write to Greg Cary

And he quickly write back, that he need to add that feature to the SmoothStepper plugin.

And will try to do it this week

Thanks  Greg