Welcome, Guest. Please login or register.
Did you miss your activation email?
May 25, 2012, 11:24:35 AM

Login with username, password and session length
Search:     Advanced search
* Home Help Search Calendar Links Login Register
+  Machsupport Forum
|-+  Third party software and hardware support forums.
| |-+  Newfangled Solutions Wizards (Moderator: Ron Ginger)
| | |-+  rectangular pockets
Pages: 1   Go Down
« previous next »
Print
Author Topic: rectangular pockets  (Read 748 times)
0 Members and 1 Guest are viewing this topic.
mack54
Holding

Offline Offline

Posts: 1


View Profile
« on: November 16, 2009, 09:14:07 AM »
Can anyone help with a few problems I have? When I call up the rectangular pocket wizard it  can load in one of two different versions, 1. shows an isometric view of the pocket and when I fill in the dimensional details it appears to work ok. 2. shows a plan view of the pocket, it has all the same dimensional details on it but it does not seem to recognise the depth steps. There does ot seem to be any way of influencing which version will come up when calling this wizard, has anyone else had this problem or am I doing something stupid?
Also if I have created a pocket with the wizard and have the G & M code and want to repeat a number of times what code should be used and what will it look like (M47 with a G52 offset or M98 with labels)? Viewing some code would help.
Thanks Mack54
Logged
Ron Ginger
Active Member

Offline Offline

Posts: 568



View Profile WWW
« Reply #1 on: November 17, 2009, 06:56:46 PM »
The Newfangled wizard will always load the same view. However, there is a rectangular pocket wizard and one that just cuts around a rectangle, but does not pocket it all out. Are you confusing the two different screens?
Logged
Pages: 1   Go Up
Print
« previous next »
Jump to:  

Powered by MySQL Powered by PHP Powered by SMF 1.1.16 | SMF © 2011, Simple Machines Valid XHTML 1.0! Valid CSS!