Set up G-code step unit question. (Newbie)

[Wednesday]

My imported g code keeps coming up much larger than my DRO capacities.

Can I change the DRO display to inches/mm's ?

Max travel (shorth of home/limits)

 X = 78" (48.000 DRO display)
 Y = 25" (6.81 DRO display)

 I convert CAD DXF's to G- Code using Cut 2D using the inch designation. The program loads but doing a test run causes
the axis to go beyond the DRO display considerably.

I know I missed a basic step some where in the set up. Can anyone help? At least point me in the correct area of the forum
to search for the answer?

Mike

[Chip]

Hi, Mike

Sounds like your machine is not setup or calibrated  properly, Under Config, "Set Default Units" to Inch mode then you need to re-do your Steps Per and re-tune Velocity and Acceleration in Config, Motor Tuning.

Hope this helps, Chip