Mach Discussion > General Mach Discussion
Servo Drive Review. First 4 drives Gecko, Viper, Rutex, Leadshine
simpson36:
'Living document' will be revised and expanded occationally but link will remain the same, so just hit it again for lastest updates.
This is only a documentation of my experiences with the products and is not an endorsment or 'buying giude'. Comments welcome.
http://www.thecubestudio.com/ServoDriveReview.htm
RICH:
Thanks for the post. Good comparative info I must say. I know it took you time and $ and sharing is
appreciated.
RICH
JHChoppers:
Thanks for the write up. I have used Geckos past with smaller servos motors and just purchased a Viper 200 to test on some larger 100V DC Servos.
I'll post my testing on the Viper 200 when I can.
Sam:
That's a good read. Thanks for sharing your knowledge and experience.
simpson36:
--- Quote from: JHChoppers on August 04, 2009, 02:55:15 PM ---Thanks for the write up. I have used Geckos past with smaller servos motors and just purchased a Viper 200 to test on some larger 100V DC Servos.
I'll post my testing on the Viper 200 when I can.
--- End quote ---
The choices that I am aware of in that price range are:
Viper 200 170V 20A $240 +$25 ship
Granite VSD-E 160v 14A $280 + ?? (ships from Finland or New Zealand)
Rutex 2020 200v 20A $230 + $12 ship
CNCdrives 180v 40A $170 + $22 (ships from Hungary)
It would be great to have reviews available for these products.
Navigation
[0] Message Index
[#] Next page
Go to full version