Problem configuring NC Pod

[frmoul]

Hi,

thanks for your advices.

There is "Deskpod.dll in C:\Mach3\PlugIns. Is that OK ?

If it does, it was automaticaly done by installing ncpod driver.

In "C:\Mach3\PlugIns\NC-Pod USB Drivers" there is ncpod.dll ; ncpod.sys and ncpod.ini
If I put ncpod.dll in C:\Mach3\PlugIns an error occur.


Regards

Freddy

[frmoul]

Hello,

The communication between mach3 and NCPod is finaly OK !!

Now I have problem to setup motors.

Is the configuration below seems ok? (i don't know what pins to put in this array)





Regards
Freddy