Welcome, Guest. Please login or register.
Did you miss your activation email?
May 24, 2012, 11:17:32 AM

Login with username, password and session length
Search:     Advanced search
* Home Help Search Calendar Links Login Register
+  Machsupport Forum
|-+  Mach Discussion
| |-+  General Mach Discussion
| | |-+  Laser for Cutting PCB Solder Paste Stencil
Pages: « 1 2   Go Down
« previous next »
Print
Author Topic: Laser for Cutting PCB Solder Paste Stencil  (Read 2169 times)
0 Members and 3 Guests are viewing this topic.
exodus
Active Member

Offline Offline

Posts: 3


View Profile
« Reply #10 on: September 28, 2010, 12:55:47 PM »
Thanks answered my question fully now i just got to get one and figure out how to connect it all up which shouldn't be hard
Logged
Tweakie.CNC
Active Member

Offline Offline

Posts: 3,253


Super Kitty.


View Profile WWW
« Reply #11 on: September 29, 2010, 01:37:50 AM »
Exodus,

Just one point that's important - Check that your existing steppers can be operated bipolar (that the have 4, 6 or 8 wires and NOT 5). The cheap Chinese boards are almost all designed for bipolar operation of steppers.

This attachment  is pretty typical of a single board instructions and may be of interest to you.

Good fortune with your project.

Tweakie.
* P4Manual.zip (10.94 KB - downloaded 39 times.)
Logged
Success consists of going from failure to failure without loss of enthusiasm.  Winston Churchill.
Pages: « 1 2   Go Up
Print
« previous next »
Jump to:  

Powered by MySQL Powered by PHP Powered by SMF 1.1.16 | SMF © 2011, Simple Machines Valid XHTML 1.0! Valid CSS!