New control computer, cant get dsp software to work.

[halkintool]

I dropped an I beam on my computer and its done.

I had my config files backed up on a flash stick, unfortunately that was on the side of the computer at the time and it got messed up too.

Anyways, replaced the head and went to re-install the software with no success.

I installed the dspMC software and tried to run the hardware ugrade tool so I could pull the config off the motion controller but I cant run either of the dsp programs. I get the error message:

"This application failed to start because the applications configuration is incorrect. Reinstall may fix the problem"

I reinstalled and restarted and no fix. I tried my old version of the dsp software as well as the new version. Any ideas why the software wouldnt run on a normal XP computer?

[vitalsystem]

looks like you need to install the attached windows package.

regards
Rufi