Welcome, Guest. Please login or register.
Did you miss your activation email?
May 23, 2012, 10:46:46 PM

Login with username, password and session length
Search:     Advanced search
* Home Help Search Calendar Links Login Register
+  Machsupport Forum
|-+  Third party software and hardware support forums.
| |-+  SmoothStepper USB (Moderator: Warp9TD)
| | |-+  crazy outputs from simple code.
Pages: 1   Go Down
« previous next »
Print
Author Topic: crazy outputs from simple code.  (Read 794 times)
0 Members and 2 Guests are viewing this topic.
turbine
Active Member

Offline Offline

Posts: 9


View Profile
« on: March 26, 2009, 02:56:07 AM »
I am trying to retune tune my drives (dc servos) since converting from P.P. I have 1 drive running at full speed now but still have a problem.
To tune, I use the following piece of code to save manually jogging back and forth.

F3000
G01 x50
x0
x50
x0
x50
x0

The problem is if I run this code with NO FRO. i.e. 100%, it will travel at 2300ish mm/min for all but the last line of code! for which it runs as instructed at 3000 mm/min?Huh?

Any help pleeeease.

Cheers,
James
Logged
boilerbots
Active Member

Offline Offline

Posts: 24


View Profile
« Reply #1 on: March 30, 2009, 04:41:08 AM »
Use Mach3 R3.042.024 and the latest drives for the SS board.

Also what is your acceleration for the X axis and do you have CV mode enabled?
Logged
Pages: 1   Go Up
Print
« previous next »
Jump to:  

Powered by MySQL Powered by PHP Powered by SMF 1.1.16 | SMF © 2011, Simple Machines Valid XHTML 1.0! Valid CSS!