MachTurn wizards

[RICH]

Ian,
When in Mach Turn just click the Wizard tab at the top of the screen and select the threading or the turning.
RICH

[RamseyT]

When in Mach Turn just click the Wizard tab at the top of the screen and select the threading or the turning.

Hi,

Where can I find some instruction on using the Turn wizard?

Half the time I put a value in, it sets it back to zero with no error message or explanation.

Do I need to be a Psychic to use them?

Ramsey

[RICH]

Ramsey,
There are no instructions.
So try it with simple / even numbers of input so you can check the posted g code.
I would recommend you set your config for radius and reversed arcs unchecked.
Make a few notes as you go along.....

RICH

[Overloaded]

also, you must hit the ENTER/RETURN key after each entry or it wont stick.