Problem with Cut Rectangle

[dacostad]

I am using version 1.90.065 of Mach 3 and keep getting errors when using the Cut Rectangle wizard.

I am running it twice to get two nested rectangles with the following settings

0.115 diameter tool
HSS
2 cutting tips
x position 0
y position 0
(in center of rectangles)
corner radius of .1
length of inner rectangle = 2"
width of inner rectangle = 0.75"
0 rotation
Conv mill
inner mill side for inner rectangle
pitch 0
rapid height 0.1
depth 0.27
step depth 0.1

for outer rectangle I use the same setting except for

length of rectangle = 2.5"
width of rectangle = 1.25"
outer mill side

When I run the wizard for the inner rectangle everything is fine, but then when I run it for the outer rectangle I get a Mach3Scripts message that says "Error on line 617 - Type Mismatch"  and then it brings up the VB scripts editor.

I suspect that I am probably doing something stupid as I am a total beginner at the Mill and CNC but it still probably should not be dealing with the error in the way it is.

Any suggestions.


Thanks

David

[Brian Barker]

thank you David, I will be looking into it.

[dacostad]

Any luck with this Brian?

Thanks

David

[Brian Barker]

Fixed for the next rev

[dacostad]

Any idea when that will be?

Thanks

David

[Brian Barker]

I will ask Art